







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Home Additions & ADU: The Huntington Beach Owner’s Guide
We build Quikrete-based home additions and ADUs in Huntington Beach in the $45,000 to $130,000 range for a home addition and $90,000 to $220,000 for a detached or attached ADU, depending on size, foundation, and finish level. Barrett & Sons Construction is an independent contractor and is not affiliated with Quikrete; we build with Quikrete concrete and masonry products because the bag mix and the sand-to-cement ratios hold up to Huntington Beach’s marine air. These are planned builds, not same-day work. A realistic addition runs four to seven months from permit to final inspection.
Owners usually start asking about this part when a project goes sideways. Maybe the previous contractor poured a slab with no vapor barrier and the concrete is now chalky and spalling near the garage. Maybe an unpermitted patio enclosure is cracking away from the house. Or maybe the HOA and the city are both asking for documents that were never filed. Whatever your situation, we’ve seen it in Huntington Beach, and we’ll tell you straight what it takes to make it right.
Key Takeaways
- Home addition in Huntington Beach: $45,000 to $130,000 installed, permits and inspections included.
- ADU construction: $90,000 to $220,000 installed, depending on size and utility runs.
- Quikrete mixes behave differently in coastal air – the bag you buy matters less than the pour.
- Every price change on our jobs arrives as a written change order before work happens.
Which Quikrete Models This Applies To

Quikrete is a brand of bagged concrete, mortar, and repair products, not a series of machines with model numbers. So “which model” is really “which mix.” The ones you’ll see on an addition or ADU job in Huntington Beach are:
- Quikrete Concrete Mix (1101) – general structural concrete, rated 4,000 psi at 28 days when mixed correctly.
- Quikrete Sand/Topping Mix (1103) – for topping slabs and thin repairs.
- Quikrete High Strength Concrete Mix (1000) – for footings and load points.
- Quikrete Mortar Mix (1102) – for block and brick, the kind that goes into a stem wall.
- Quikrete Fast-Setting (1004) – for small repairs only; not for structural pours.
How to identify what you’re looking at on an existing job: read the stamped date on the bag if it’s still around, check the mix number on the pallet label, and match it against the pour plan. Bag date matters more than most people realize – Quikrete bags have a shelf life of about a year, and old bags lose strength. If a crew used expired mix on a footing, you’ll find out when the inspection fails.
On the OEM-vs-aftermarket question: with Quikrete there isn’t an OEM-versus-aftermarket split the way there is with a garage door spring. The decision is really “Quikrete bag mix versus ready-mix truck.” For anything bigger than a small footing or a repair, a ready-mix truck is cheaper per yard and more consistent. For a small residential addition in Huntington Beach, bag mix makes sense for patches, stem walls, and small slabs. We’re upfront about which is right for your project before we quote. We don’t stock bags in a warehouse or carry them on a truck. What we do is specify the right mix and make sure it gets poured correctly.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Home Additions & ADU Is Failing
Concrete failures in coastal Huntington Beach have a signature. Here’s what to look for:
- Spalling or flaking on a slab face. Almost always a vapor barrier problem or a mix that was too wet at pour. You’ll see it first on a garage slab or a south-facing patio slab where the sun hits hardest.
- Hairline cracks that widen each season. Normal shrinkage cracks stay put. Cracks that grow with each wet-dry cycle point to a footing that’s moving, often because it wasn’t dug below the local frost line or wasn’t keyed into the existing structure.
- White chalky powder on the surface. Efflorescence. It’s salt being pushed out of the concrete by moisture. On a Huntington Beach addition it usually means water is getting in somewhere and has nowhere to go.
- Separation where the addition meets the house. A cold joint that’s opening up. Could be missing rebar dowels, could be a bad pour joint, could be settling.
- Soft or chalky concrete that crumbles under a hammer tap. This is the bad one. It means the mix was wrong, the pour was too hot, or the curing was skipped. If you can scratch a footing with a screwdriver, it needs to come out.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what Quikrete-based additions and ADUs run in Huntington Beach, with the range explained:
| Project | Installed Range (Huntington Beach) |
|---|---|
| Home Addition (room, primary suite, in-law) | $45,000 – $130,000 |
| ADU Construction (attached or detached) | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
What drives the range: foundation complexity, roof tie-in, whether the addition needs its own utility runs, and finish level. A simple room addition on a flat lot sits near the low end. An ADU with a full kitchen, bath, and separate electrical service pushes toward the top. The Quikrete portion is usually a smaller slice of the whole – the concrete, mortar, and block work – but it’s the slice that determines whether everything above it stays level for the next forty years.
Our quotes are line-item and written. Every scope, every allowance, every price change arrives as a written change order before work happens. We pull the permits and sign the inspections. The permit inspector works for you, not for us – that’s why we like him. And every job is backed by the 90-Day Done Right Promise: if it isn’t done right, one call brings Tom back to fix it.
DIY or Call Us?
Some things a homeowner can safely check without lifting a shovel. Reading the date stamp on leftover Quikrete bags, measuring crack widths with a feeler gauge, and photographing efflorescence for a record are all fair game. Walking the foundation line and noting where the house is and isn’t level is useful information to have before you call anyone.
What we don’t recommend is trying to repair or extend a structural footing, pour a slab that ties into the house, or patch a load-bearing stem wall yourself. It’s not the mixing that gets people – it’s the fasteners, the dowels, the vapor barrier, and the inspection sign-off. A bad repair on a Huntington Beach addition isn’t just a re-do. It can become a disclosure problem when you go to sell, or a stop-work order if the city finds out. If you’ve got a failing Quikrete foundation or a patched-up slab that’s coming apart, call us at (844) 320-2945 and we’ll tell you what it actually needs.
FAQs

A properly mixed and cured Quikrete footing or slab will hold up 50 years or more in coastal Southern California, as long as it has a vapor barrier underneath and the mix wasn’t overdiluted. The failure mode in Huntington Beach isn’t age – it’s moisture intrusion from grade problems and marine air. Get the drainage right and the concrete will outlast the roof.
Sometimes yes, sometimes no. Hairline shrinkage cracks and surface spalling can usually be repaired with a topping mix. Structural cracks, chalky footings, or a slab that’s separating from the house cannot – that’s a re-pour. Call (844) 320-2945 and we’ll give you a free second opinion on any written estimate you already have.
The pour itself is usually one to three days. The curing time before you can frame on top is seven days minimum, and 28 days for full design strength. On a Huntington Beach addition, we plan the schedule around the cure so we’re not rushing it. Total project, permit to final inspection, is four to seven months.
We specify the right Quikrete mix for the application – high strength for footings, standard concrete mix for slabs, mortar mix for block – and buy it fresh from a local supplier for each pour. We don’t warehouse bags and we don’t carry them on a truck. If you want to see the mix spec before we buy, we’ll write it into the scope. Old bag date is the number one cause of weak concrete, and we check every pallet.
Barrett & Sons Construction is an independent Huntington Beach contractor and is not affiliated with Quikrete. We also install KraftMaid, Cambria, and Silestone on the interior portions of additions and ADUs. Call (844) 320-2945 to schedule a free estimate on your Huntington Beach addition or ADU.
Written by the team at Barrett & Sons Construction Huntington Beach, serving Huntington Beach and nearby areas.












