







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Dvele Home Additions & ADU: The Huntington Beach Owner’s Guide
We build Dvele-compatible home additions and ADUs in Huntington Beach, and installed projects typically run $45,000 – $130,000 depending on whether you’re adding square footage to the main house or building a detached unit. We handle the engineering, the permits, the inspections, and the site work that has to match Dvele’s modular shell and connection points. This isn’t a same-day repair; a real addition or ADU takes months and we schedule the free estimate like any planned construction job.
Owners usually call us after the shell is up and something downstream stops working. A Dvele panel joint that won’t hold a finish. A utility chase that doesn’t line up with the local service. A slab or footing that was set before the module arrived. In Huntington Beach we see this most on coastal lots where the marine air and salt push a builder to get the envelope sealed and the addition dried-in fast, and any gap in that sequence shows up a year later as a crack or a moisture line.
Which Dvele Models This Applies To

Dvele builds panelized and modular homes, and the connection points on a Perpetua, an Amador, or an earlier series don’t match each other. Before we quote an addition, we measure the actual as-built: the wall panel thickness, the ceiling height at the interface, the electrical gutter location, and the plumbing stub orientation. Those four measurements decide whether your addition ties in cleanly or needs a framed transition. The nameplate and the as-built drawings are where you start; don’t trust the sales brochure dimensions.
The OEM-versus-aftermarket question matters less on an addition than on a roof vent or a window, because the “part” here is a structural tie-in, not a bolt-on. What we can do is match finish materials and systems to what Dvele specified so the new section looks like it came from the same drawing. KraftMaid and Cambria carry through the interior if you’re matching a kitchen wall; Silestone works too. Barrett & Sons Construction Huntington Beach is an independent contractor and not affiliated with Dvele, so we don’t sell their hardware, we build the addition around it.
How to identify what you’re working with:
- Find the model nameplate inside the mechanical closet or on the panel near the service entry.
- Pull the as-built set that came with the home; the panel schedule shows thickness and joist spacing.
- Measure ceiling height at the addition wall, not at the room center; sloped or vaulted panels throw this off.
- Photograph the utility gutter and the stub-out positions before we visit; it speeds the estimate.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Dvele Home Additions & ADU Is Failing
These are the symptoms that tell us a Dvele home in Huntington Beach needs an addition or ADU tie-in problem resolved, not patched:
- Hairline cracks along a panel joint. The joint is moving because the foundation or footing settled differently than the module assumed. Left alone, the crack opens and lets moisture into the wall cavity.
- Moisture staining at the roofline where the new section meets the shell. The flashing detail at the transition wasn’t built for our marine layer. This is the most common failure we see on coastal Huntington Beach additions.
- A door that sticks seasonally in the new addition. The framing is racking or the header is undersized for the span. A sticking door is often the first visible sign that the tie-in isn’t carrying load the way the plan intended.
- An electrical chase that’s short of the service panel. The module’s gutter was set for the original footprint; the addition’s circuits don’t reach. This needs a licensed electrician and a permit, not an extension cord.
- A slab or footing that doesn’t line up with the module’s bearing points. If the site work was done before the as-built was confirmed, the addition has to be re-engineered to bridge the gap.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed home addition costs in Huntington Beach run $45,000 – $130,000. An attached addition that ties into the Dvele shell sits on the lower to middle end; a detached ADU runs $90,000 – $220,000 because of the separate foundation, utilities, and inspection sequence. A garage conversion falls in the $30,000 – $80,000 range if you’re converting existing space instead of building new.
What drives the number:
| Line item | Typical range |
|---|---|
| Attached home addition (site-built tie-in) | $45,000 – $130,000 |
| ADU construction | $90,000 – $220,000 |
| Garage conversion to living space | $30,000 – $80,000 |
Every scope, allowance, and price change comes to you as a written change order before the work happens. We pull the permits and we get the inspections signed. The finished job is backed by our written 90-Day Done Right Promise.
DIY or Call Us?
An owner can safely do a few things here: photograph the joint and the roofline transition, measure the room, collect the as-built drawings, and note where the sticking door and the moisture stain appear. Those notes make our estimate sharper.
What you shouldn’t do yourself is structural. Tying a new addition into a Dvele shell, cutting a header, or moving an electrical chase all involve load paths and permit sign-off. A bad structural tie-in on a Huntington Beach addition can void your inspection and put the whole module’s warranty at risk. Call (844) 320-2945 and we’ll tell you straight whether it’s a real structural issue or a finish-level fix, and the estimate is free.
FAQs

How long does a Dvele addition or ADU last once built? A properly engineered and permitted addition to a Dvele home should last as long as the original structure, 50 years or more, provided the roof transition is flashed for coastal conditions and the foundation is built to our soil report. The failure isn’t the design; it’s the tie-in. Call (844) 320-2945 for a free estimate.
Can a failing Dvele addition be repaired instead of rebuilt? Often yes. A panel joint crack or a moisture line at the roofline can be repaired with proper flashing and reframing if the structure hasn’t moved. Foundation misalignment usually means re-engineering rather than patching. We can tell you which after we see it. Call (844) 320-2945 to schedule the estimate.
How long does the addition or ADU take? An attached addition typically takes several months from permit to final inspection; a detached ADU runs longer because of the separate foundation and utility trench. The free estimate includes a written schedule. Call (844) 320-2945 to get that timeline.
How do you source the materials for a Dvele home? We don’t sell Dvele parts and we’re not affiliated with Dvele. We measure the as-built shell, then source finishes and systems that match what the plan calls for, from named brands we can verify. Call (844) 320-2945 for a free estimate and a written line-item quote.
Written by the team at Barrett & Sons Construction Huntington Beach, serving Huntington Beach and nearby areas.
Call (844) 320-2945 for a free estimate. Barrett & Sons Construction Huntington Beach pulls the permits, issues written change orders before any scope change, and backs every completed job with the 90-Day Done Right Promise. Our technicians have up to 28 years of experience, and a live person answers the phone 24/7.












